CALIBRE Press-it Hole Puncher Kit

• CR-V steel

• The Press-it hole puncher kit is designed for punching holes into bumpers to mount parking sensors.
• The sizes of the holes are different from vehicle to vehicle.
• Previously the holes were drilled by stepped drill bits. The problem is that the bumper is unusable if the hole is too deep.
• Advantages of the kit: With the different cutters you can switch between hole sizes.
• Thus the holes have the optimal diameter to set the parking sensors.
• Another advantage of the Press-it System is that pressing in the holes is taken place after the painting.
• The varnish is moved in at the edges and as a result there are no sharp edges.
• Because the sensitivity of the sensors, they have to be fixed in millimeter precision to guarantee a proper function.
• By using the mandrels, which are also included in the Press-It kit, the sensors are getting assembled in a very precise way.
• The different mandrels depending on the size of the cutters.
• Easy and professional punching of holes, according to the requirements of most automobile manufacturer
• With the right cutter a custom-fit hole is punched into the bumper

• Punch & Mandrel Ø18.2: Supplies usual models from: BMW, Volkswagen
• Punch & Mandrel Ø24.0: Supplies usual models from: Opel
• Punch & Mandrel Ø26.0: Supplies usual models from: Volkswagen
• Punch & Mandrel Ø32.0: Supplies usual models from: BMW

• 1 x hole punch/centring mandrel set, 2-piece, Ø18.2 mm for VW/Seat
• 1 x hole punch/centring mandrel set, 2-piece, Ø18 mm BMW/Skoda
• 1 x centring mandrel Ø17.8 mm for VW/Seat
• 1 x hole punch/centring mandrel set, 2-piece, Ø18.4 mm for VW
• 1 x hole punch/centring mandrel set, 2-piece, Ø24.0 mm for Opel/Vauxhall
• 1 x hole punch/centring mandrel set, 2-piece, Ø26.0 mm for VW/Seat
• 1 x hole punch/centring mandrel set, 2-piece, Ø26.7 mm for VW/Skoda
• 1 x hole punch/centring mandrel set, 2-piece, Ø27.4 mm for Skoda
• 1 x hole punch/centring mandrel set, 2-piece, Ø28.1 mm for Skoda
• 1 x hole punch/centring mandrel set, 2-piece, Ø32.0 mm for BMW
• 1 x hole punch Ø32.5 mm for BMW (without centring mandrel, as the PDC sensor is mounted at an angle)
• 1 x hole punch Ø38.9 mm for VW (PSA) (without centring mandrel, as the parking steering assistant sensor is mounted at an angle)
• 1 x hole punch drive, 3/8-inch with ball bearing
• 1 x drill bit, Ø10 mm

• 1Set/Blow Mould Case
• CAJ0091: 10Set/15/16kgs/2'
  CAJ0091-1: 5Set/14/15kgs/1'